- Parts for Braumeister
- Parts for Grainfather
- Stainless steel equipment
- Sparge and recirculation
- Barrel Accessories
- Cockpit for probes
- Stainless steel fittings
- Spare parts & Accessories
- Not just beer
Long brush to easily clean the inside of the Springer filter or Tubes
In addition to the internal cleaning of the Springer, it is very useful to eliminate mechanically the protein film that over time is formed in the inner wall of pipes for which the use of hot water and a normal detergent is sufficient.
The brush has a diameter of 20mm and is 10cm long, the soul of the brush is in stainless steel aisi316
The elongation is obtained by a Perlon cord 4mm diameter 1,3 meter long
Threaded ends for insertion of the hook and the brush
How to clean a springer
-Immerse the Springer in soaking in hot water and normal detergent
-Thread the end with the hole in the Springer filter until the brush touches the Springer
-Fix the side with the hole at some point, a hook, a gusset, a vise.....
-At this point, push the Springer until the brush is escaped.
CAUTION: DO NOT PULL the springer but PUSH otherwise the coils widen, the strands of the brush enter between the coils and it becomes difficult to remove it
Total length 165cm
Spare parts disc large mesh for Yeld increase disc BM200
Spare parts kit for springer fitting, new version, hole height 50 mm
Spare parts kit for springer fitting, new version, hole height 60 mm
New version Complete kit for springer filter in a Braumeister BM20 / 50 with hole height 50mm from the bottom
Prodotto indispensabile per la pulizia dei tubi di travaso con rimozione totale dei residui.
Utilizzato per lo springer, ottima soluzione