- Parts for Braumeister
- Parts for Grainfather
- Stainless steel equipment
- Sparge and recirculation
- Barrel Accessories
- Cockpit for probes
- Stainless steel fittings
- Spare parts & Accessories
- Not just beer
With this filter disc in AISI304 stainless steel specific for Braumeister BM20 you will no longer need to buy spare parts as it is not made with mesh but with micro-perforated and stretched sheet. You will no longer have the problem of fraying the weft which, in addition to considerably ugly the filter, makes it difficult to clean with the risk of even pinching your fingers.
Obtained by shearing a micro-perforated sheet therefore, obviously, the edge cannot be smooth but has tips which, however, being a single piece, do not fray with use. By zooming the image you can see the border
The filter disc with 0.9 holes is slightly smaller than the original.
The filter disk with 1.5 holes is slightly larger than the original
Almost all of them use the filtering disc with 0.9 holes, the most similar to the original, but those who have tried the 1.5 filtering disc do not change it anymore. Pump flow increases, efficiency also increases by 4 points. Very important is the correct grinding with the right amount of flour, this is learned with experience. Obviously some small pieces can escape because the holes are bigger
Spare parts kit for springer fitting, new version, hole height 60 mm
New version Complete kit for springer filter in a Braumeister BM20 / 50 with hole height 60mm from the bottom
tolles Produkt, bin gespannt auf das nächste Brauen
Good Replacement for Original Part
This is a well made after market part which is, as advertised, easier to clean as the original. Furthermore, it has a much smoother edge so you will less likely sting your fingers during cleaning. I would choose this filter over original any day.
BAC brewing plates
Like the picture shows, fraying mesh discs are a pain. The BAC plates work well and are very robust. I had no difficulty obtaining good flow through the discs. Efficiency not hampered at all.