- Parts for Braumeister
- Parts for Grainfather
- Stainless steel equipment
- Sparge and recirculation
- Barrel Accessories
- Cockpit for probes
- Stainless steel fittings
- Spare parts & Accessories
- Not just beer
With this filter disc in AISI304 stainless steel specific for Braumeister BM50 you will no longer need to buy spare parts as it is not made with mesh but with micro-perforated and stretched sheet. You will no longer have the problem of fraying the weft which, in addition to considerably ugly the filter, makes it difficult to clean with the risk of even pinching your fingers.
Obtained by shearing a micro-perforated sheet therefore, obviously, the edge cannot be smooth but has tips which, however, being a single piece, do not fray with use. By zooming the image you can see the border
The filter disc with 0.9 holes is slightly smaller than the original.
The filter disk with 1.5 holes is slightly larger than the original
Almost all of them use the filtering disc with 0.9 holes, the most similar to the original, but those who have tried the 1.5 filtering disc do not change it anymore. Pump flow increases, efficiency also increases by 4 points. Very important is the correct grinding with the right amount of flour, this is learned with experience. Obviously some small pieces can escape because the holes are bigger
Spare parts kit for springer fitting, new version, hole height 60 mm
New version Complete kit for springer filter in a Braumeister BM20 / 50 with hole height 60mm from the bottom
Spare parts disc large mesh for Yeld increase disc BM200
Basta vedere le foto per capite di cosa si stia parlando. Prodotto di qualita' extra.
As always the quality is superb !
This is really the best filter you can imagine!
I bought the fine filter mat to replace the top filter. The fear that this might be too fine turned out to be unfounded. I turned the pumps on the BM 50 back from 9 to 5 and got the best results.