Long brush for springer or silicone tube

Long brush to easily clean the inside of the Springer filter or Tubes

In addition to the internal cleaning of the Springer, it is very useful to eliminate mechanically the protein film that over time is formed in the inner wall of pipes for which the use of hot water and a normal detergent is sufficient.

The brush has a diameter of 20mm and is 10cm long, the soul of the brush is in stainless steel aisi316

The elongation is obtained by a Perlon cord 4mm diameter 1,3 meter long

Threaded ends for insertion of the hook and the brush

How to clean a springer

-Immerse the Springer in soaking in hot water and normal detergent

-Thread the end with the hole in the Springer filter until the brush touches the Springer

-Fix the side with the hole at some point, a hook, a gusset, a vise.....

-At this point, push the Springer until the brush is escaped.

CAUTION: DO NOT PULL the springer but PUSH otherwise the coils widen, the strands of the brush enter between the coils and it becomes difficult to remove it

Total length 165cm