Keg filler with spunding valve

New item made in BacBrewing for keg with isobaric technique, pressure display, complete with automatic and adjustable spunding valve for overpressure relief, complete with silicone tube to avoid dirtying the keg when the foam or beer comes out.

5/8" version Completely made of stainless steel (except for the 5/8 ring nut made of nickel-plated brass).

1/2" version Completely made of stainless steel

Pressure gauge and Bourdon spring inside the pressure gauge made of stainless steel Aisi 316.

Pressure gauge with 0-4 bar scale placed in a vertical position to prevent possible entry of beer into the Bourdon spring.

Spring inside the automatic spunding valve made of stainless steel, shutter in FDA silicone.

Complete with male jolly gas connection with FDA silicone o-ring for CO2 saturation of the keg.

Totally removable for perfect cleaning and sanitization

Suitable for keg head type A or S with 5/8" or 1/2" thread

-Methods of use-

Screw the keg filler to the keg head with 5/8" or 1/2" thread

Please remember that the non-return valves inside the keg head must be removed

Attach the keg filler to the keg

-Presaturation-

Turn the pressure regulator clockwise for approximately 15 turns

Connect the CO2 inlet to the jolly connection

Open the CO2 inlet and bring the pressure to a level greater than the desired keg level. For example, if you want to brew at 1 bar, set the pressure to 1.5/2 bar

Once you reach the pressure of 1.5/2 bar, rotate the pressure regulator anti-clockwise until the pressure gauge pointer starts to drop, rotate again but slowly to reach the desired pressure. To facilitate setting the pressure, we recommend inserting the silicone tube and immersing the end in a sanitizing solution to see when the CO2 stops coming out.

It is advisable to carry out a new CO2 load several times to check the correct pressure at which the bubbles stop coming out. If necessary, make the appropriate adjustments. Once the correct pressure has been verified, block the actuator using the blocking butterfly.

At this point the keg filler is set to operate at 1 bar

Disconnect the CO2 jolly gas connection

-Keg filling-

Open the beer inlet valve, the spunding valve automatically opens and releases the pressure which increases inside the keg.

At the foam outlet, wait until the beer comes out, close the inlet valve, wait for the pressure to reach 1 bar and unhook the keg filler from the keg.

To keg filling again there is no need to perform a new calibration.

-Cleaning-

Once you understand the method to follow, calibration is a very simple phase so it is advisable to completely dismantle the keg filler for perfect cleaning.

It is not recommended to immerse the pressure gauge in sanitizing solutions or you can immerse only the threaded part while keeping the pressure gauge vertical

Follow the assembly diagram

-Supply-

Keg maker complete with all its parts (Type A or S keg head not included)

50cm FDA silicone drain hose

Instructions manual

-------------

-Optional-

Complete kit of spare parts (spring, shutter and all gaskets)

Removable three-piece ball valve beer inlet for type A or S keg head with 5/8 thread 

Jolly gas connection complete with John Guest 3/8

FDA silicone o-ring spare parts kit for the Jolly gas/beer male connection

FDA silicone drain hose

Glycerine pressure gauge filling service