- Parts for Braumeister
- Parts for Grainfather
- Trub Stopper 400 microns
- Tecnological cap for barrel
- Shovel whirlpool
- Hop Basket
- Springer (bazooka)
- Cockpit for probes
- Thermal probe
- Vision, measurement, control
- Sparge and recirculation
- Ball valves inox 3 pcs
- Adhesive seal silicone Food Grade
- Threaded fittings inox ISO-4144 E EN 10241
- Silicone gasket
- Silicone tubes
- Various parts
- Spare parts
Hop Boil 25x50 cm ( d10xh20 inch)
Ø10" h20" Vol 6.6 gal cap. 5.5lb
New model of basket for boiling hops with telescopic handle for adjusting immersion as desired in order to exploit the full capacity of the basket.
Diameter 25 cm (10") height 50 cm (20") Volume of the basket 25 liters (6.6 Gal), with a ratio of 10lt / 1kg is equivalent to a capacity of 2.5kg (5.5lb) of hops
Made in AISI 304 stainless steel, 3mm thick, 20mm bar width.
Electrodecaped, electropolished, passivated by immersion for at least 3 hours in compliance with the EU MOCA directive and the ASTM 380-967 USA directive, the most restrictive directives regarding the stainless steel parts coming into contact with food
The fixed bottom flange and the mobile flange cut by laser are expressly designed by BacBrewing to not allow the hop to come out but at the same time the possibility to disassemble the basket in all its parts
Bottom and wall filter elements made of microperforated stainless steel sheet, NOT MESH
Available in three filtering screens. 250, 400 and 800 microns
250 microns Perfect for pellet hops with no spills
400 micron Good for pellets with the possibility of slight spills. Perfect for cones, leaf, pressed plugs.
800 microns Not suitable for pellets. Perfect for cones, leaf, pressed plugs. Slight spills of small pieces given by the pulverization of the pressed hops.
Complete with a telescopic handle to adjust the immersion of the basket
Built on request, ready to ship time around 5 working days